[Close]
Tooling right angle heater
Outer right-angle heaters use high-strength lead oxide ceramics with good thermal radiation as the insulation material, and use high-quality nickel-chromium-silver cables as heating elements, plus various types of iron shells. In cotton, the well-connected heater can be either an external right-angle heater or an internal right-angle heater. This mainly depends on the position and angle of the fillet weld. Because it is made of iron shell type, it is very convenient and simple to use! Nickel-chromium wire cables and wires are welded by a new process. The soldered joints are all embedded in the ceramic components. The insulation is reliable. Ceramic heaters and control equipments become complete heat treatment systems. Their connection uses special connectors and can be based on The length of the control device is configured with long wires. The right-angle heater can be flexibly changed in the length dimension. The corresponding specifications should be selected according to the geometry, wall thickness and heat treatment process of the workpiece. The following table lists only some of the specifications. Model Heating Size (mm) Working Pressure (V) Rated Voltage (KW) Applicable Pipe Diameter Bendable edge × straight edge LCD26-220 660×330 220 10 Φ219 LCD33-220 860×260 220 10 Φ273 LCD39-220 1020×220 220 10 Φ325 LCD44-220 1160×200 220 10 Φ377 LCD52-220 1360×160 220 10 LCD70-220 1860×120 220 10 LCD19-220 500×450 220 10 Φ159 LCD16-220 420×530 220 10 LCD19-110 500×220 110 5 Φ159 LCD16-110 420×260 110 5 LCD23-110 600×180 110 5 LCD10-55 260×200 55 2.5 LCD16-55 410×120 55 2.5